U大师U盘动盘制作工具详细步骤教你如何安装系统.doc

U大师U盘启动盘制作工具 详细步骤教你如何安装系统 要问现今最流行的U盘启动盘工具是什么，当然是u大师U盘启动盘制作工具，大家都在使用，教程非常详细，三步到位，而且附带图片，相信大家一看都能懂。 第一步：准备工作 准备一个U盘和到U大师官网上下载的U盘启动盘制作工具。 第二步：安装系统 1、运行“U大师-U盘启动制作工具 .exe”文件，选择对应的U盘作为启动盘，点击“一键制作USB启动盘”。 2、弹出提示框，提示U盘重要数据备份，若U盘有重要数据的可以先单独备份，避免数据丢失，若已经备份则点击“确定”开始制作USB启动盘。 3、制作USB启动盘的时候会将U盘原先的数据格式化。 4、制作完成之后会弹出提示框，点击“确定”，将U盘安全删除并拔出重新插上便可用U盘当作启动盘来使用。 安装到硬盘第一分区1、ghost文件copy到U盘GHO目录下2、文件名改成auto.gho。 3、重启系统从U盘启动选择【05 DOS下安装系统GHO到硬盘第一分区】。 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finishing. bearing surface, markup should be in accordance with the mounting support pads