侧发光面板灯和背发光面板灯的区别.ppt

Shenzhen Glitter Optoelectronic Technology Co., Ltd Products Introduction LED PANEL LIGHT ————Advantage of our Panel Light Direct lighting compare to Edge lighting (we make) (From others) 1.Thickness———direct lighting Our panel is direct lighting Chip (PCB) stick in the bottom of the panel Lighting view 1.Thickness———direct lighting Beam angle of the Chip Beam angle of the SMD 3014 is 120 degrees, the red point in the picture is the lighting cross point of two chips. 1.Thickness————direct lighting Diffuser should be lower than the red point, so that the lighting mix effect is good enough, and no dark point in the panel 1.Thickness————direct lighting This is why our panels so thick, thickness is 46mm~50mm 1.Thickness————edge lighting Edge lighting is thin 1.Thickness————edge lighting Thickness of edge lighting is only 15mm, because all the chips are stick on the edge of the panel (not in the back side of the panel) 1.Thickness————edge lighting Light emitting of the edge panel is : 30% of light should be reflect by plate (back part) to diffuser, it will loss some luminous of each chip (see the red line), it will lost 20% of luminous compare to the direct lighting 2. Heat Dissipation Good heat dissipation will help to reduce the luminous degradation and extent lifespan of products 2. Heat Dissipation——Direct lighting Big heat dissipation area, the whole back part is the heat dissipation, (effective heat dissipation is base on the size of the heat dissipation area), heat dissipation area of direct lighting is much bigger than edge lighting) 2. Heat Dissipation——edge lighting Edge lighting with narrow heat dissipation area, only the edge part is the heat dissipation. So many chip crowded in narrow edge, it is much heat than direct light. So the luminous degradation must be more than direct lighting 3. Diffuser Diffuser we used is imported from Japan, it have the best light mixing effect and ve