温湿度计程序.docVIP

/*********************************************************************************** Project: SHTxx 驱动程序 4位数码管移位扫描显示 ***********************************************************************************/ #include reg51.h //Microcontroller specific library, e.g. port definitions #include intrins.h //Keil library (is used for _nop()_ operation) #define uchar unsigned char #define uint unsigned int #define outdata P0 //8951mcu enum {TEMP,HUMI}; sbit DATA=P2^1; sbit SCK=P2^0; #define noACK 0 #define ACK 1 #define MEASURE_TEMP 0x03 //000 0001 1 #define MEASURE_HUMI 0x05 //000 0010 1 #define RESET 0x1e //000 1111 0 //-------------------硬件配置---------------------------------- //P0口为段码数据，P1.4, P1.5, P1.6, P0.5 分别为1234位数码管 //===================显示段码数据============================== uchar duanma[10]={0x28,0xeb,0x32,0xa2,0xe1,0xa4,0x24,0xea,0x20,0xa0}; //===================位控制=================================== sbit WEI1=P2^7; sbit WEI2=P2^6; sbit WEI3=P2^5; sbit WEI4=P2^4; //8951 //====================按键配置================================= //==========================显示缓冲区RAM配置================== uchar buffer[4]={0,0,0,0}; uchar wd,sd; union { unsigned int i; float f; }wendu,shidu;//定义两个共同体，一个用于湿度，一个用于温度 //==================================================== void delayHM(uint k)//毫秒级延时子函数 { uint i; uchar j; for(i=0;ik;i++) { for(j=0;j121;j++); } } //=================移位扫描显示函数===================== void led_dispy(uchar bu[]) { uchar i; for(i=0;i4;i++) { outdata=duanma[bu[i]]; switch(i)//位选控制 { case 0: WEI1=0;break; case 1: WEI2=0;break; case 2: WEI3=0;break; case 3: WEI4=0;break; } delayHM(1); WEI1=WEI2=WEI3=WEI4=1; } } char s_write_byte(unsigned char value) //---------------------------------------------------------------------------------- // 写字节函数 { unsigned char i,error=0; for (i=0x80;i0;i/=2) //shift bit for masking { if (i value) DATA=1; //masking value with i , write to SENSI-BUS else DATA=0; SCK=1;