工艺参数对薄壁件多道次旋压变形均匀性的影响-精密成形工程.PDFVIP

摇 摇 摇 摇 摇 摇 精 密 成 形 工 程 第6卷摇 第2期 摇 摇 摇 摇 JOURNAL OF NETSHAPE FORMING ENGINEERING 摇 2014年03月 摇摇摇 18 工艺参数对薄壁件多道次旋压变形均匀性的影响 缪伟亮,刘大海,邵雪明 (南昌航空大学 航空制造工程学院,南昌330063) 摘要: 目的摇 研究成形工艺参数对薄壁件多道次旋压变形均匀性的影响。 方法摇 采用试验的方 法,研究了双轮数控旋压成形铝合金薄壁件过程中,旋压间隙啄、进给率f 和旋轮圆角半径R 等关 键工艺参数,对制件表面质量和壁厚均匀性的影响。 结果摇 3 个工艺参数都对制件表面质量和壁 厚均匀性有影响。 结论摇 减小旋压间隙啄、采用较大的主轴转速S和较小的进给率f 可提高零件的 表面质量和尺寸精度。 改善零件壁厚分布的均匀化程度,适当提高旋轮圆角半径R,也能使变形的 均匀化程度提高。 关键词:铝合金;薄壁件;多道次旋压 DOI:10.3969/ j.issn.1674-6457.2014.02.004 中图分类号:TG306摇 摇 摇 摇 文献标识码:A摇 摇 摇 摇 文章编号:1674-6457(2014)02-0018-06 Effects of Forming Parameters on Deformation Uniformity of Thin-walled Parts during Multi-pass Spinning MIAO Wei-liang,LIUDa-hai,SHAOXue-ming (School of Aeronautical Manufacturing Engineering,Nanchang Hangkong University,Nanchang330063,China) ABSTRACT:Objective To studytheeffectsofformingparametersonthemacrodeformationuniformityofthethin-walled aluminum partsduringmulti-passspinningprocess. MethodsTheinfluencesof spinninggap啄,feedratef ,andspinroller fillet radiusR on the quality of thepart surface andtheuniformity of wall thicknesswere experimentally investigated inthe formation process of thin-walled aluminum parts using double wheeled spinning machine. Results All thress forming pa鄄 rameters had influence on the quality of the part surface and the uniformity of wall thickness. Conclusion The results showed that the surface quality,size precision andthicknessuniformity of the partswere improved by decreasing the spin鄄 ning gap啄,orusingahigher spindlespeedSwithalowerfeedratef . Andabigger spinrollerfilletradiusalsoresultedin much more uniform deformation. KEY WORDS:aluminum alloy;thin-walled