AutoCAD 06-1(国外英语资料).doc

AutoCAD 06-1(国外英语资料) The sixth chapter is two-dimensional object editing Drawing graphics is not enough to use only drawing commands, and in many cases you must resort to graphical editing commands. AutoCAD2006 provides numerous graphical editing commands, such as moving, rotating, zooming, copying, deleting, cutting, and so on. The utility model has the advantages of reasonable construction and organization of graphics, ensuring the accuracy of drawing, and reducing repeated drawing operations so as to improve the drawing efficiency The rate of. 6.1 object selection Many editing commands for AutoCAD require that you select one or more objects for editing. When the object is selected, AutoCAD displays them in dashed lines to show off. There are many ways to select objects, including options: Window, Wpolygon, Crossing, Cpolygon, Fence, All, Previous, Last, Add, Remove, Multiple, Auto, Single, Undo and so on. These object selection methods do not appear on any menu or toolbar, but in the AutoCAD prompt to select objects for use at any time. Several commonly used are introduced. Select object: The process of starting an object selection. 1.Point - point selection method In the select state, AutoCAD will replace the screen cross cursor with a small box called object pickup Draw box. You can select objects directly with the pickup box. Each time you select an object, select the object: prompt will repeat Now. Under the select object: prompt, press the space key or Enter key to indicate the accepted selection and exit the object selection Status. In AutoCAD 2006, if you select the drop-down menu, Tools Options choose use When the Shift key is added to the selection, this option (as shown in Figure 6-6), when you select an object, hold down the Shift key Multiple objects can be selected, whereas multiple objects can be selected continuously. 2.W (Window) - window mode options This option allows you to select all objects contained in a rectangular area. At the select