proe野火与proe2001的区别(国外英语资料).doc

proe野火与proe2001的区别(国外英语资料) [turning] PROE wildfire skills (plus personal grooming) can also be said about the difference between 2001 and wildfire 2011-06-24 11:58 Reprinted from ivanliao2009 Finally edited ivanliao2009 A Build layer: at the middle of the model tree, display / tree layer / right-click in the blank layer, select new layer, then you can build a new layer, Draw a dotted line: draw the line, select the line and press CTTL+G button on the linear conversion, in the sketch should not be changed under the double point line, can only draw after modified type, select line after right click, select properties, the attribute selection: linear simulation, application of good B 1., a friend asked SECTIONs position, as follows: TOOL---MODEL SECTION, in the automatic command bar, enter what you need, and then ENTER, OK! 2. guys, big, wildfires RELATION in there? Tool - Relation 3.. How do you handle Toroidal bend in wildfire??? Insert---- advanced ------Toroidal bend 4. excuse me, where is the Adv Utils/cut out in the assembly diagram? Edit - Conponent Operation 5. to perform feature operations on [EDIT in wildfire, you must first select the features you want to operate. At first, the commands below EDIT were all grey and thought the PROE version was a problem. How the 6. wildfire into Chinese, I started to use the wildfire, thank you for your In config, help_translation, dialog_translation, and dialog_translation are set to yes. Add lang = CHS in the environment variable. 7. how do you get Wildfire to appear in the ProE2001 waterfall menu? Function table application = inheritance Where is the two projection curve of the 8. Wildfire command? In the first two plane sketch curve, and then the two curves just drew, click on the intersect, two projection line out, sketch curve and two projection line no relationship between father and son, can delete sketch curve and the two projection line unchanged, there are two projection line just drew curves. Look at it yourself.