zhuangxiu(国外英语资料).docVIP

zhuangxiu(国外英语资料) 1, after the pre cleaning, you can install the floor of the site. As the 3 floors of solid wood flooring do not need to keel, so the requirements of the site is higher, it needs to be pre arranged, including leveling, cleaning, drying and so on. 2. This is the buckle used to separate the floor of each room. The distance between the buckles is 8mm, so that enough space can be left for the expansion of the floor. 3 drill holes at the threshold and play out the deep holes for fastening the bars. 4 use the nail to fix the lower part of the buckle bar in the hole just made. Cut cut in the lower end of the door machine with 5 workers, because without a keel, the top floor to go in, to keep the beautiful. 6 buckle and door is handled well, can be seen between the two there is a certain gap for floor insert. 7 double layer moistureproof film. Below a layer to moisture, above a layer of thick, slightly elastic (pictured), in addition to outside moisture can also play a role in improving the foot. 8 the workers are laying a damp proof film underneath. 9 moisture barrier must be completely covered with the entire paved ground, where the joint should be sealed with tape. 10 the workers are sealing the moisture film on the top floor. Similarly, the seams of the film should be sealed with tape. 11, the entire moisture-proof film is paved, and then you can lay the floor. 12 ply solid wood flooring. Different with wood floors, 3 wood flooring interface has a special interface (Figure), the installation can be tightly fastened, more stable. 13 cut the floor according to the measured size. 14 to two floors. The interface between the fixed and firm, not loose, to be fixed in special glue is coated on both sides of the interface in the floor before installation. This kind of special glue sticks firmly and has good environmental protection performance 15, tapping the floor from the side, so that the interface between the floor to better fix, then the surface of the fl