地下工程注浆操纵工艺(国外英语资料).docVIP

地下工程注浆操作工艺(国外英语资料) Grouting operation technology in underground engineering 1. concrete surface treatment Use small hammer, wire brush and sand paper to repair the surface of debris, scum, rust and other things removed, should pay attention to prevent the cracks in the process of cleaning plug. Crack should be dipped with acetone or xylene cotton silk scrub, generally not flush with water, because the resin afraid of contact with water. If the water must be washed, but also to be completely dry moisture, before you can carry out the next process. 2. closed In order to ensure the success of grouting, a closed body must be formed outside the crack. Closed mouth, paste paste including glass cloth (or full Guanizi and pointing). When the first closed mouth cloth, the method is: 1) no matter what kind of seam, seam end should be set mouth, if the slot is intermittent, for preservation purposes, in place on both sides of the mouth with a discontinuous; 2) nozzle and a nozzle distance, straight slot is generally 40-50cm, the level of joints must be added mouth 3); through the straight and inclined seam, both sides should set mouth, and should be staggered arrangement. According to the principle of first in the mouth cloth with a pencil to draw on the concrete, with a trowel to epoxy putty scraping has been used in solvent wipe the grouting mouth plate, thickness of 1-2mm, static 15-20 seconds after the paste to position. In order to prevent the leakage around the mouth, along with putty around the chassis and sealed. When not put a glass cloth, crack mouth between the putty to straddle put into wide 2-3cm thick long belt, to seal the cracks, and the gap on both sides of the scope of the 2-4cm should be full Guanizi again. Concrete is a porous material, there are still possible leakage from a certain area on both sides of the joint of grout, so you need to stick to the closed glass cloth. The patch should be filled bubble eye or uneven concrete, and then use the brush brus