地砖面层施工工艺(国外英语资料).docVIP

地砖面层施工工艺(国外英语资料) Floor tile surface construction technology I. main points of construction 1, the concrete floor should be the base chisel hair, chisel hair depth 5~10 mm, chisel hair mark spacing is about 30 millimeters. After the clean dirt, grease, mortar, producing scattered brush major ground water. 2, before the shop is stuck should play a good line, at right angles to the base line on the ground and began to pop up the doorway, play the line from the door, in order to assure the entrance for the whole brick, the whole brick in Yin angle or under the furniture, elastic thread should pop up freely positioning control. 3, paving ceramic ground brick before, should first be ceramic tile to soak dry up. 4, the shop is stuck, the cement mortar should be full with ceramic tile floor in the back, after the shop is stuck with a rubber hammer hammer. At the same time, use horizontal ruler to check and clean the surface cement mortar. 5, shop 2~3 hours after finishing, with white cement to wipe seam, with cement, sand, =1:1 (volume ratio) of cement mortar, seam to be filled with dense, smooth and smooth. Wipe the surface with cotton silk. Two 、 construction preparation (I) material preparation Floor tile, cement, sand, water, interface agent Uniform appearance, color, smooth surface, neat corners, no cracks, missing edges, corners and other defects Sand is medium sand or coarse sand, 5mm pore size sieve, its mud content is not greater than 3%. (two) equipment preparation 1.: mechanical sand mixer, desktop and portable wheel saw marble machine, angle grinder. 2. tools: rubber hammer, shovel, rake, trolley, sieve, bucket, scraping bars, wood trowel, iron trowel, greed, hammer, broom etc.. 3. measuring tools: level, scale, steel ruler, square, on foot, nylon line, level etc.. 4. safety protection articles: masks, gloves, goggles and so on. (three) working conditions; Indoor elevation control line (ten 500mm or + 1, 000mm) has been played well, large area construction shou