1安全工程师生产技术模拟题及答案(国外英语资料).docVIP

1安全工程师生产技术模拟题及答案 Safety engineer production technology simulation questions and answers A RadioButtonList (every day, 1 points, 70 points) 1., the explosion of oxygen bottle directly heating belongs to (). A. B. of C. explosive detonation physics chemical explosion detonation D. 2. plant building materials, non combustible refractory limit should not be less than (). A, 20 minutes, B.0.5 hours, C.1 hours, D.1.5 hours 3., according to the national code for building design fire protection, the single storey factory building of the class A shall not exceed the safe evacuation distance. A.30 B.50 C.60 D.75 4., the initial concentration of fuel mixture increases, and its explosion limit range will be (). A. narrowed, B. broadened, C. unchanged, and D. irregularly changed 5. in order to speed up the diffusion of flammable gases, the long axis of the building and the dominant direction of the plant shall be (or) greater than 45 degrees. A. parallel B. vertical C. is no less than 45 degrees D. less than 30 degrees 6. what safety work should be done first when the machine tool is finished? (). A. clean machine B., shut down machine tool electrical system and cut off power supply, C. lubrication machine tool, D. cleaning machine tool Which of the following injury incidents is most likely to occur in the 7. cold stamping production? () A. finger B. joint injury, C. burn, D. chip injury 8. stamping die should have enough (), in addition to the work part, shall not have (). The stiffness of A., B., C. angle obtuse angle obtuse angle strength strength, stiffness, D. 9. shearing operation, () is not safe. A. two people at the same time in a stand of two kinds of materials B. shears shear steel bar in the narrow bed shear to compress to C. put the clutch in neutral position after D. stop and start the matching safety device 10. which of the following is wrong with the operation of the shearer? () A. operation should be carried out before empty test transfer, before B. operation, in