AUTOCAD打印问答(国外英语资料).doc

AUTOCAD打印问答 AUTOCAD print question and answer Release date: 2010-5-1 [collection comments did not find the desired knowledge] Q: after the PLOT and ASE commands, there is only a prompt on the command line, but no pop-up dialog box. Why? Answer: AutoCADs system variable, CMDDIA, is used to control the dialog box of the PLOT command and the ASE command. The setting of CMDDIA is 1, and the problem can be solved. Question: print out the effect is very poor, the line has gray difference, why? A: most of this is related to the configuration of the printer or plotter, the driver, and the operating system. Usually from the following considerations, you can solve the problem. When the A. is configuring a printer or plotter, is the error jitter switch off?; Is the driver of the B. printer or plotter correct and does it need to be upgraded?; C. if the AutoCAD is configured to output as a system printer, change the AutoCAD printer by using AutoCAD as a ADI driver for all types of printers and plotters; D. provides the corresponding commands for different types of printers or plotters, and can be further detailed configured by AutoCAD. For example, for a series of graphs that support the HPGL/2 language, use the command hpconfig; E. in the AutoCAD Plot dialog box, set the pen and pen color and line type and width corresponding relationship; specify the same pen as different colors (preferably with 1), but the corresponding number of linear pen and pen width, can be different. Some inkjet printers can only support 1-16 of the pen number and cannot print if the pen number is too large; Is the width of the f. pen too large, for example, greater than 1?; The g. operating system, if it is Windows NT, may need an updated NT patch (Service Pack). Q: after installing R14, what fonts are missing in MS WORD? Whats the matter? Answer: the reason that affects the MS WORD font is related to a virtual printer installed by R14 for the system called Phantom AutoCAD OLE/ADI. The Phantom AutoCAD