压力传感器输进旌旗灯号不稳旌旗灯号的弊病剖析(国外英语资料).doc

压力传感器输出信号不稳信号的故障分析 Fault analysis of unstable signal of output signal of pressure sensor The output of the pressure transmitter is not changed, the output of the pressure transmitter is changed suddenly, and the zero position of the pressure relief transmitter can not be returned. The reason of this phenomenon is most likely caused by the pressure sensor ring, usually because of seal specifications reasons (too soft or too thick), tighten the sensor, the sealing ring is compressed to the pressure sensor inside the mouth jam sensor. The pressure up, this situation not to output, should first check the pressure interface is leaking or blocked, if not, check the connection mode, if the wiring is correct then check the power supply, such as the power supply is normal again on the sensor zero if there is output, or simply to see whether the output pressure change, change that sensor is not damaged if there is no change, the sensor has been damaged. Other reasons for this may be instrument damage or other aspects of the system. The pressure when the pressure medium to go in, but a lot of pressure when suddenly rushed to open the sealing ring, the pressure sensor by pressure changes, while the pressure decreased again when the sealing ring is also blocked the return pressure, residual pressure release out, so the sensor zero down again. The best way to remove this reason is to remove the sensor, check whether the zero is normal, and if you change the seal, try again. The output signal of transmitter is unstable and the reason of unstable signal is as follows: The A. pressure source is itself an unstable pressure B. instrument or pressure sensor anti-interference ability is not strong? The C. sensor is out of wiring The D. sensor itself is very vibrating The E. sensor fault transmitter has no output power possible: F. connect the wrong line (both instrument and sensor should be checked) G. the wire itself is broken or shorted H. power supply, no output or power mismatch I.