变压器继电爱惜剖析!(国外英语资料).doc

变压器继电保护分析! Analysis of transformer relay protection Transformer relay protection is used when the transformer internal and external faults, the current and voltage, temperature change, determine the nature and scope of the transformer fault by these sudden changes, to find, and to make the appropriate response and handling. After checking and handling the relay protection action, if it is confirmed to be quick break protection action, the signal sound can be temporarily lifted. If the gas protection, first check whether the gas protection action, such as no action, that fault in the transformer exterior, focus on examination of transformer and high voltage circuit breaker to transformer power supply line, cable, bus to see whether there is fault phase. In addition, we should also focus on the transformer high-voltage lead, there is no obvious fault points and other obvious anomalies, such as transformer injection, fire, temperature rise too high. If it is found that the gas action, you can basically determine the fault in the transformer. One is that when the transformer windings and core insulation layer between the local short circuit, bad, and serious transformer oil spills, oil drop, light gas will move; when a catastrophic failure of the transformer, such as a winding fault caused by phase short-circuit fault current, the transformer produces strong airflow and oil flow, the impact of heavy gas the baffle, the heavy gas operation, circuit breaker tripping and signals. Two, if there were no obvious anomalies in the transformer at that time, the gas of the transformer can be collected, and further analysis and determination of the nature of the fault can be made. If the gas is collected into a colorless, tasteless, and non combustible, explain the action of gas relay is oil discharge caused by air; if the gas collected is yellow, not easy to burn, that is part of wood transformer fault; such as gas is light yellow with a strong odor and flammable, for insulation