基带信号的码型(国外英语资料).doc

基带信号的码型 baseband signal When receiving, the radio frequency signal is demodulated and decoded before receiving the signal; when transmitting, the transmitting signal before the audio coding is modulated, i.e., the signal has been coded but not modulated. People are used to calling it I and Q signals. But in fact, because of the development of chip technology, baseband signals are transmitted in the computer board in the form of data stream, such as V70, etc.. ... You Tektronix oscilloscope measurements are not baseband signals, jump the DC level, the baseband signal frequency is 67KHz, in the Samsung 600 mobile phones in the most obvious test. Again: digital oscilloscope in the mobile phone there is no simulation of good, especially in the mutant signal observation. 4.1 code type of digital baseband signal 4.1 code type of digital baseband signal Knowledge points in this section: Code design principle of digital baseband signal, common code type, digital baseband signal power spectrum Code design principle of 4.1.1 digital base band signal The so-called digital baseband signal, that is, the message code of the electric pulse - Electrical waveform. In the baseband transmission system, the original digital baseband signal not all can transmit in the channel, for example, the baseband signal is rich in DC and low frequency component is not suitable for transmission in the channel, because it may cause serious distortion of the signal; for example, the general base band transmission system is a bit synchronous signal from the received signal, code and bit synchronization signal is dependent on the code, if the code has a long time. 0 symbol, then the baseband signal may appear for 0 time Thus, the bit synchronous recovery system can not guarantee the accuracy of bit synchronous signals. The actual baseband transmission system may also make other requirements, resulting in various possible requirements for baseband signals. To sum up, there are two main requirements for