定轴变速箱的弊病揣摸方法(国外英语资料).docVIP

定轴变速箱的故障判断方法 Fault diagnosis method of fixed axle transmission The model loader, torque converter, and transmission are two separate assemblies. When the failure of the walking capacity occurs, most of the torque converters and transmissions were disassembled before, and the inspection was carried out, resulting in low maintenance efficiency and high maintenance costs. In this regard, we have in-depth study, decided not to disassemble the torque converter and transmission, through observation, inspection and testing, to diagnose torque converter and transmission work whether there is a fault. 1. torque converter fault diagnosis (1) detect torque converter inlet and outlet pressure, torque converter inlet pressure valve, working pressure is 0.4~0.7MPa, oil outlet pressure valve working pressure is 0.25MP a. If the oil pressure is abnormal, adjust to normal value. (2) check whether the converter output power starting loader operation, operation if the engine is running normally and walk to, allows the loader to continue operations, and will increase the engine speed, rotation of the main drive to watch the converter to the transmission shaft, judge the fault occurred in the torque converter. When the engine speed increases, if the main transmission shaft decreases or does not rotate, the torque converter fault can be diagnosed. (3) to observe the main transmission shaft moves with high speed and low speed control lever in neutral position, the engine speed operation, the transmission handle in any way, and will be going in and out of the handle in the forward - backward - forward position toggle. The careful observation of action in reversing the main driving torque to the transmission shaft of the main transmission shaft, if instantaneous pause or slow down (about 1/2s) but immediately and quickly spin up, that the torque converter is normal; if the main drive shaft rotation weakness or long time no rotation is that torque is there a fault. (4) listen to the torque