汽车发念头气缸压缩压力的测量(国外英语资料).doc

汽车发动机气缸压缩压力的测量 Methods of measurement and determination of numerical values Before the measurement of cylinder pressure, should first remove all of the spark plug, will be back to zero the meter touch on the measured cylinder spark plug a hole (some cylinder pressure gauge is screwed in the spark plug on). Start the engine, to observe and remember the first time beating hands numerical means. Loosen starter, hands back to zero. The same procedure repeated measurements, but each measurement should be based on the highest hand first beat can reach the standard. The numerical first can jump is the real pressure cylinder. If the measurements are uneven, the low values indicate that the piston does not start at full intake and compression. It is worth emphasizing that each cylinder must be measured several times over and over again to determine the exact value of the cylinder. 2. other understanding of different measurement methods and values Another way is to measure the cylinder pressure gauge contact in a cylinder spark plug socket, connect the starter in the piston pressure, gas pressure from zero to a pointer value, do not immediately stop the operation of the starter, but did not stop the rotation of the starter piston, continuous repeated compression, repeatedly push the intermittent beating, until the hands will not rise so far, the highest value reached by hand is the cylinder pressure. The highest cumulative value as hand cylinder pressure value is. I think: if in the same cylinder, piston compression stroke first hand reaches 800kPa, the starter was turning second times, compression stroke pointer to 900kPa; also the crankshaft continues to rotate, the third pointer and compression stroke based on 900kPa rose to 1000kPa. In the three in hand to beat high numerical every time, that had a compression stroke, will beat a. Hand in this three intermittent elevated pressure in the first compression stroke belongs to the 800kPa on the basis of the relay of up to 900