深圳东森考场科目三考试步骤(国外英语资料).doc

深圳东森考场科目三考试步骤 1) prepare after getting on the bus After you get on the bus, put your files, ID cards in the side seat, fasten your seat belts, adjust the seat, the rearview mirror; Check the switch is hit to the right (generally already open), check left and right steering lamp is working properly, check whether the normal light switch; Clutch in the end, in turn hang 1,2,3 files, try its transmission lever feel; finally, gently step on the accelerator, to see its gas, about to step on more vigorously only response. When everything is checked, the staff members are already urging you to take the fingerprint exam. Ignore him and see if there is a Parking in front of the exam. 2) start Confirm according to the fingerprint: open the lamp, closed around the turn lights, turn off the high beam light, neutral, pull the handbrake. In front of the vehicle to leave the project after stopping, press the paper pattern, suggested please start examination, then the clutch and brake, turn left turn lights, horn, hanging 1 stalls, release the handbrake, slowly release the clutch start, turn the steering wheel to the left, to be the starting left back immediately, is the steering wheel, straight into the pull project. 3) pull over At this point, please pull over, hit the right turn light, and hit the steering wheel to the right, because the test vehicle has no test car several words, Only the number of cars, such as 07, 48 As a result, the parking has changed, and the coaches have different methods. My approach is to use the front right of the car in the center of the road to the right edge of the line For example, No. 07 test car, take 0 to the right edge of the road line, when the two together, you can step on the brakes, parking. After parking, idling, pull the handbrake, close a steering lamp. To pull over complete, open the left turn lights, horn, hanging 1 stalls, loose handbrake, slow release clutch starting, starting immediately after the completion of hanging 2 stalls, In