用好AutoCAD的线型比例(国外英语资料).docVIP

用好AutoCAD的线型比例 Use the linear ratio of AutoCAD Whether we use AutoCAD, R14 or 2000 graphics, we have to use a variety of different lines, such as dotted lines, dotted lines, central lines, etc.. Some AutoCAD users often find themselves clearly in advance set point line, but the output line, the reason is often due to lack of understanding of scale set by the question is: what is the scale? How do I use line scale in drawing? The use of a variety of line drawing in AutoCAD, in addition to the CONTINUOUS line, each line is a sequence composed of the solid line segment, segment, point blank, text or shape, line type definition file is already defined in the standard length of the short. The length of each segment displayed on the screen is proportional to the scaling factor and linear proportion of the display, while each length of output to the printer or plotter is proportional to the ratio of output to line type. When the displayed or printed line is out of order, the length of each line can be enlarged or reduced by changing the linear proportional system variables. Most of the line has three seeds, such as CENTER, CENTER2, CENTERX2, DASHED, DASHED 2, DASHEDX2 and so on, in the form of three in general, the first line is the standard form, the first half of the second linear linear proportion, third linear proportion is two times in a linear. If the lines drawn are too short (not solid) so that the software cannot draw the dotted line feature of the line type, the AutoCAD will draw a continuous solid line between the two endpoints. But sometimes the line to line ratio is not set properly, it will also make the output line solid line. The linear scale is divided into three categories: the global scale factor, the scaling ratio of the current object and the linear scaling ratio of the drawing space. The global scale factor controls all new and existing linear scaling factors. The zoom ratio of the current object controls the linetype ratio of the new object. The lin