电吉他要如何调试(国外英语资料).doc

电吉他要怎么调试 How do you adjust the electric guitar?: 1. electric guitar trussrod (Trussrod) trussrod principle is through the extension and contraction of the bolts on the neck in the middle to exert a force on the neck, the neck to balance the string tension, maintain the shape of the neck. 1. if your adjusting bolt in the head, then in accordance with the direction will be shown to make bolts tight to the back, neck, string from the fingerboard closer to.2. if your neck - in adjusting bolt body joints, then in the opposite direction to tighten screw bolt. The adjustment parameters are: capo (or hand) hold 6 string 1, hand on the last 6 string, see the top eighth products and goods silk 6 string the bottom distance is about 0.10 ( inch, 0.10 inches is approximately 0.25 mm), can be measured with a feeler (professional hardware stores (Radius) with different curvature radius of the neck neck, on behalf of the neck. The specific index of each piano can be checked on their website Specs) the requirements are highly different, but also not much, I will list these standards and their unit conversion Radius neck height: 7.25 184mm 0.012 0.30mm 9.5 to 241mm 12 to 304mm 0.010 0.25mm, 15 to 17 381mm to 432mm 0.20mm note 0.008 here is to adjust the neck need to be very careful, not to pull too hard, a little bit, sometimes you have to wait again look, start again. If you hit a hard wrench, dont pull it off and go to a professional to solve it 2. guitar bridge (Bridge/Saddle) bridge regulation regulation is divided into two steps: 1. chord length (String Height:Fender) regulation organ in 17 products, product measurement wire to the highest point of the lowest string distance criteria are as follows: Radius neck bass treble strings side side 7.25 184mm 5/64, 1.98mm 4/64, 1.59mm 9.5 to 12, 241mm to, 304mm 4/64, 1.59mm 4/64, 1.59mm 15 to 17, 381mm to, 432mm 4/64, 1.59mm 3/64, 1.19mm Gibson Qin in 12 products, measurement of product wire to the highest point of the lowest string di