电工初级试题(国外英语资料).docVIP

电工初级试题 Intermediate and intermediate questions for electrical engineering Fill in the blanks 1. The rotor of DC motor is composed of armature core, winding commutator, rotating shaft and fan blade. It is an important part of energy conversion. 2, the excitation mode of DC motor can be divided into its excitation, shunt excitation, series excitation and compound excitation. 3, DC motor under the rated load operation, the # level should not exceed 1.5 level. 4. The rated capacity of three-phase transformer is the maximum apparent power that is allowed to output when the rated voltage of the winding is not higher than the rated value. It is equal to two times the product of winding rated voltage and current tick 3 times. 5, in the operation of the transformer, the loss caused by the thermal effect of the winding current is usually called the copper loss; loss caused by alternating magnetic field in the core can be divided into hysteresis loss and eddy current loss, collectively known as the iron loss. 6, because the transformer short-circuit test current is larger, but the voltage is very low, so generally in the high pressure side pressure, so that the low voltage side short circuit. 7. The part of the motor winding unit embedded in the slot is called the effective part, and the part outside the slot is called the part. 8, three-phase asynchronous motor rotating magnetic field is decided by the power of the phase sequence, in operation, if the rotation of the rotating magnetic field changed, the rotors steering will change. 9, Y series AC motor insulation level is B level. 10. The rotor of synchronous motor has two kinds of salient pole and hidden pole. The rotor of general diesel generator and synchronous motor used in factory is convex type. 11, three-phase asynchronous motor speed depends on the magnetic field, the pole number P, slip S and power frequency f. 12, winding drying often adopts the following three methods: drying room, drying method, bulb drying method