离子烫的正确做法(国外英语资料).docVIP

离子烫的正确做法 The popularity of the popularity of hot plasma is everywhere, whether it is the size of hair shops, or urban and rural hair shop, ion hot seems to be the magic weapon to make money, but more time? Let me happy, let me worry. Ion hot has gone through 7 years, has come to an end, and the rate of re ironing can be said to become a serious worry. I through years of ion hot research found that the failure of ion hot mainly for the following two reasons: 1, softening problems: many hair stylist to soften the grasp there are many problems, not not in place, is excessive, and cause hair tail disorderly curl, Maomao dry. Therefore, the correct grasp of the degree of softening is the key to the success of ion hot. While the first agent smear is caused invisible killer softening failure, we must first understand the basic situation of the hair, then according to the condition of reasonable apply, can greatly improve the success rate of softening. Im here to discuss some tips with you: The damaged hair smear method: apply to the damaged parts before spray a little oil or conditioner, put roots 2 cm outside the health site, then coated with hair damage, try to control the speed smear in 5~8 minutes. Tests should be done in different parts of the test. 2, the board temperature problem: temperature controller now most splints are not accurate, for example, we use 180 degrees of operation, possible splint temperature has risen to more than 200 degrees, and the degree of heat hair for 120 degrees, more than 200 degrees high temperature can imagine the hair stand, finished hair tail will appear disobedient or Maomao the phenomenon of. The correct operation is as follows: Healthy hair board temperature: 160 degrees, a speed for every 3~6 seconds to move a plate width, dont pull back and forth. Splint temperature of damaged hair: between 120~140 degrees, preferably in the healthy part two times, then from the root hair to the hair tail slowly pull. The hair at the end dont Do