ls-dyna预应力加载简绍,相当详细.ppt

Preloads in LS-DYNA;Preload - Introduction;Explicit Dynamic Relaxation (DR);Explicit Dynamic Relaxation;*CONTROL_DYNAMIC_RELAXATION;*CONTROL_DYNAMIC_RELAXATION parameters IDRFLG Flag to activate DR (not required if DR is activated with *DEFINE_CURVE) Set to 2, will invoke a completely different and faster initialization approach … Initialization by Prescribed Geometry. Requires supplemental input file containing nodal displacements and rotations (“m=filename” on execution line). Such a file drdisp.sif is written at conclusion of standard DR run. If nodal rotations are not included in file, method is invalid for beams and shells. LS-DYNA? runs a short transient analysis of 100 timesteps to preload the model by imposing the nodal displacements and rotations. Solution then proceeds with regular transient analysis. Set to 5, activates implicit method for solution of preloaded state Must also set DRTERM to signal end of DR phase. *CONTROL_IMPLICIT... provide controls on implicit phase. ;Output Related to Dynamic Relaxation;Output Related to Explicit Dynamic Relaxation;Typical Loads During Dynamic Relaxation;Explicit Dynamic Relaxation;Dynamic Relaxation;Dynamic Relaxation;Transient Stress Initialization ;Transient Stress Initialization ;Preload via Implicit Analysis;Preload via Implicit Analysis;Preload via Implicit Analysis;Bolt Preload ;*LOAD_THERMAL_LOAD_CURVE;*CONTACT_..._INTERFERENCE;*CONTACT_..._INTERFERENCE;*CONTACT_..._INTERFERENCE ;Preloading a Solid Cross-section to a Known Stress ;*INITIAL_STRESS_SECTION ;*INITIAL_STRESS_SECTION ;Initial Forces in a Beam ;Initial Forces in a Beam ;Initial Forces in a Beam