cad高级技巧(国外英语资料).docVIP

cad高级技巧(国外英语资料) The default setting of the new face version: the tool - the option - the system - starts - displays the start dialog - determines. Unit: the decimal Angle: the decimal point Angle: the east direction: counterclockwise for the positive direction Area: A3, 420mm, 297mm Turn on the CAD tools: view -- toolbars -- to draw, modify, annotate, capture, and check. (right-click on a common toolbar and open it.) Roller scrolling can amplify and shrink the image. Hold down the roller and drag. Line: L is orthogonal: F8 To create two lines, the input C is closed, and U can be retracted. ESC can cancel the exit abort command. Space/enter: repeat the previous operation. Offset: o Method: select offset - enter the offset distance return - direct single line segment to the desired offset - right over. Pruning: tr (pruning redundant parts of the line) Method: select pruning -- right-click in the blank space -- click on the right click to trim the image -- right-click to end. A one-off clip: choose a trim -- click on the reference to the image -- right-click in the blank space -- enter F enter -- Click on two points to create a line segment (across all the lines to be pruned) -- right over. Extension: EX Method: select extension - right-click - the right click to extend the image - right-click to end A quick, rapid extension of the image: select extension - click on the left button to the image - right-click - enter F enter - Click on two points to create a line segment (this line must select all the ones you want to extend) - right-click. Round: C Method: 1, drawing -- circle -- the center and radius (diameter) -- click the center -- enter radius/diameter enter 2, draw -- the circle -- two points/three points -- point two at three. Draw -- circle -- tangent to the tangent radius -- click the first pointcut -- click the second slice -- Enter radius enter (circle and circle/line and line/circle and line) 4, drawing -- the circle -- tangential tangent -- click three poin