cisco常用配置命令(国外英语资料).docVIP

cisco常用配置命令(国外英语资料) Cisco AP configuration method mainly has the console port login, remote login (such as Telnet/SSH), a Web browser, etc., after the two ways are all need to get or set a IP to login. In general, the method for setting the IP address of an AP is obtained by default, configured by DHCP, using IPSU (IP Setup Utility), and using the console port. In fact, for Cisco AP, the easiest way to configure it is to use a Web browser method, GUI. Cisco AP has two basic GUI interfaces, one for IOS GUI, such as Arionet 1100; One is the VxWorks GUI, such as the AP and bridge of Arionet 350. The Arionet 1200 series supports both GUI interfaces. The following picture Cisco Aironet 1100 series of AP GUI configuration interfaces: In addition to GUI and remote login methods, the CLI (command line) is also a commonly used configuration method for Cisco. The GUIs configuration method is simpler because it is not covered in length. Below we configure the Cisco AP in the CLI (command line) mode. Cisco AP IOS CLI (command line) configuration mode are: user, privilege, and the global model, interface model, line model and so on, its basic configuration commands and command prompt, routers and switches based on Cisco IOS CLI mode is basically the same, if you are looking for was not familiar with all kinds of patterns, please refer to the basic model of router and switch configuration section. Configure the host name The step configuration command explains 1 ap# configure terminal goes into the global configuration mode 2 ap (config) # hostname name configures the host name 3 ap (config) # end returns to the privilege EXEC schema 4 ap# show running - config view configuration information 5 ap# copy running - config starup-config saves the configuration information Note: the hostname name in the command name must conform to the rules of the ARPANET host name, the name for a maximum of 63 characters, and must begin with a letter, end must be a letter or number, can only be lett