trunk端口都必须有pvid(国外英语资料).docVIP

trunk端口都必须有pvid(国外英语资料) What is pvid (2009-03-16 21:34:39) Whenever the switch trunk port must have pvid, because the trunk link can send and receive frame and unmarked frames marked by 802.1 q. If the trunk port receives a marked frame, it will read the vlan id in the tag and send it to the corresponding vlan port. If an unmarked frame is received, the trunk port considers the frames vlan id to be the pvid configured on the trunk port, so the frame is sent to the vlan port that is consistent with the trunk port pvid number. For example, if the trunks pvid is vlan 10, the trunk accepts the frame that is not marked and forwards the frame to the vlan 10 port. In addition if a frame enters ready to send to the next switch, check the frame from the trunk port switch which vlan to receive, if and trunk port pvid does not match the hit 802.1 q tag to send, if it is from the pvid belonging to a vlan, is not playing tag to send. , for example, may accept a switch from a vlan to a data frame and sent to the next switch, and the trunk of the switch port pvid vlan to 10, and the trunk of the switch port call the frames on the vlan id 802.1 q tag and send to 5, while the frame from the switch vlan 10 accept when sending wont play tag. One thing to note is that all the Ethernet frames are tagged with tags inside the switch. Pvid works mainly in the following cases. When there is a blank of switch Ethernet frames, exchange opportunities for the Ethernet frames with the port pvid, if the Ethernet frame is 802.1 q tag tag, the tag again and receive port pvid different then switches will not do any action. When an Ethernet frame with the tag signs from a port, if the tag and the port pvid different switches still dont do any action directly release, if the same may be off the tag markup. So when does pvid change? The pvid changes when the port is set to the access port. Pvid English is parsed to the port - base vlan id (some of the data is parsed to port vlan id), which is a vlan id