华为交换机 基本命令(国外英语资料).docVIP

华为交换机 基本命令(国外英语资料) system - view enters user mode display courrent-config looks at the current configuration display version views the IOS version on the switch sysname hostname switch name For example, Hostname 2403A is called 2403A The dispaly interface looks at the statistics for all the interfaces dispaly int? To view all available Ethernet and fast Ethernet commands. dispaly int Ethernet? Ethernet dispaly int e 0/2 to see the statistics table for the two interfaces reset devaluation-configuration removes configuration information from flash or NVRAM. The original value = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = Switch port basic configuration: Configure ports: First step: system-view enters the system configuration state Step 2: interface {port - range} enters the port configuration state Step 3: quit Step 4: display interfaces [interface - id] verify port configuration Step 5: sasve current - config Configure port speed and dual mode The Ethernet can be configured with 10/100mbps and 10/100/1000mbps, but the GBIC port argument can be configured rate and dual mode. When the join does not support the other 1000 ports of adaptation. First step: system-view enters the configuration state Step 2: interface interface - id enters port configuration state Step 3: duplex {10 | 100 | 1000 | auto |} set port speed Step 4: duplex {auto | full | half} set full duplex or half duplex Step five: quit Step 6: display current - configuration shows the configuration Step 7: save out 3, port description First step: system-view enters the configuration state Step 2: interface interface - id enters the port that is to be added to the description Step 3: description string joins the description port Step 4: quit Dispaly interface interface - id descriptoin Or dispaly current - config validation Step 6: save Monitor an