框架结构构造措施(国外英文资料).docVIP

框架结构构造措施(国外英文资料) The frame structure is defined by Liang Hezhu as rigid or hinged connected to the structure of the bearing system, which is composed of frame beams and columns appear to resist in the process of using horizontal and vertical load. The non load bearing wall structure, only to surrounding and separating effect, general use of aerated concrete, prefabricated expanded perlite, porous brick, hollow brick or pumice, vermiculite, ceramic materials such as masonry or light plate assembly. Section size of beam The following requirements shall be met: (1) the width of section shall not be less than 200mm; (2) the aspect ratio should not be greater than 4; (3) span and section height ratio of not less than 4. Liang Kuan When the flat beam is larger than the width of the column, the floor should be cast in place, and the small line of the beam should coincide with the central line of the column. The flat beam should be arranged in both directions and should not be used in the frame structure of the first class. The section size of the flat beam shall meet the following requirements and shall meet the current regulations concerning the deflection and the width of the crack: Reinforcement arrangement of beam The following requirements shall be met: (1) the reinforcement ratio of the longitudinal tensile steel bar at the end of the beam shall not be greater than 2.5%. The ratio of the height of the compression zone to the effective height of the concrete at the end of the beam, which is included in the compressive reinforcement, shall not be greater than 0.25., and the two or three grade shall not be greater than 0.35. (2) the ratio of the reinforcement ratio between the end of the beam end and the longitudinal reinforcement of the top section shall not be smaller than 0.5, but the class two or three shall not be less than 0.3. (3) the length, the maximum spacing and the minimum diameter of the stirrups of Liang Duan stirrups should be adopted in table 12-29. Whe