覆膜技巧(国外英文资料).docVIP

覆膜技巧(国外英文资料) With time, for most people, whether novice or have many years working experience in advertising people, film is simple, not worth mentioning, but to cover 1.5 meters large picture picture, often have a headache, because one is not careful, it may be a problem, the film wrinkle, causes the entire the picture is discarded, people really feel pity, learning the following methods are of great help to everyone in the film when. The film through the laminator, leveling, pull down the hand length, the film will not retreat out on the line. The photo paper through the laminator, paper machine is very slippery, always hand to suppress. After passing, press with your hands and walk to the other side. Flatten the edges of the paper and the film and carefully align the edges. Check the edge alignment and press it while checking. Check the other side. After the alignment, roll down the pressure roller, lower the pressure roller, attention, I will not say more, used to believe that all know. After pressing, you can let go, check again, if found out of alignment, again. After the alignment, roll the paper over the press roll. The paper is usually rolled. Once it is turned on, it will stick to the roller. If it doesnt stick, it will be put on the transparent adhesive. Peel off the protective coating of the film. So long, peel to be technology, otherwise, stripping to one end and once again began to peel when should first fold, stripping to the middle when first folding side, of course, the best there is a better way. After stripping, press the protection layer, press the photo paper with your hand, and slowly turn back the pressure roller. Go back, hand press the photo paper, dont let the paper fall. Watch carefully and back to the head. Dont let the paper and film fall out. Turn a little further after the end. Make sure that the press roller does not rotate. If you are not sure, press a triangular piece of wood between the two rollers, and then turn the paper over th