南京师范大学研究生matlab大作业.docxVIP

南京师范大学计算机辅助工程设计课程设计与报告题目：基于SIMULINK的并网逆变器的仿真研究学院：电气与自动化工程学院专业：电气工程学号：姓名：指导教师：填写日期：南京师范大学研究生课程学习考试成绩单（试卷封面）院系电气与自动化工程学院专业电气工程研究生姓名陈丽学号151835004课程名称计算机辅助工程设计授课时间2015-2016第一学期周学时2学分2简要评语文中为实现同相并网并使并网电压电流同相，采用锁相环控制技术，将空间矢量控制技术运用到风电并网逆变控制中。本文主要计算直流侧电容与交流侧电感的取值范围，设置逆变器个器件的仿真参数，将逆变器模块在Simulink上进行仿真，仿真结果表明本文设计的逆变器达到了预设的目标，并网频率在0.3HZ以内，并网电压和电流的纹波都不超过10%，并网电流与电压同相，实现了单位功率因素并网，且输出电压波形畸变率低，电流波形十分接近正弦波。考核论题总评成绩（含平时成绩）备注任课教师签名：批改日期:注：1、以撰写论文为考核形式的，填写此表，综合考试可不填；2、本成绩单由任课教师填写，填好后与作业（试卷）一并送院（系）研究生秘书处；3、学位课总评成绩须以百分制记分。中文摘要我国风电产业发展迅速，装机容量巨大，然而，在风电“量”发展的同时，“质”却有待加强，风电并网这一瓶颈问题仍未彻底解决，故如何实现高质量风电并网成为本文思考的问题。本文针对直驱式风电系统进行了全面的研究，着重探讨了风电并网逆变器的并网实现，取得了良的并网效果。本文主要计算了直流侧电容与交流侧电感的取值范围，并根据需要设置了逆变器个器件的仿真参数，将逆变器模块在Simulink上进行仿真，通过反复调试确定了适宜的参数值，仿真结果表明本文设计的逆变器达到了预设的目标，并网频率在0.3HZ以内，并网电压和电流的纹波都不超过10%，并网电流与电压同相，实现了单位功率因素并网，且输出电压波形畸变率低，电流波形十分接近正弦波。关键词：直驱风电并网系统、并网逆变器、双闭环控制、SPWMAbstractChinas wind power industry has developed rapidly, huge capacity, however, at the same time, wind power quantity of development, quality but needs to be strengthened, wind power bottleneck issue is not completely resolved, it is how to achieve high-quality wind power become this article thought. In this paper, direct-drive wind power system to conduct a comprehensive study, focused on the wind power inverter and net realized and achieved good effect of the grid.This paper calculates the DC side and AC side inductance capacitance ranges, according to the simulation parameters need to set up a device of the inverter, the inverter module simulation in Simulink, through repeated testing to determine the optimum parameter values The simulation results show that the design of the inverter reaches a preset target, grid frequency within the 0.3HZ, and grid voltage and current ripple does not exceed 10%, and net current and voltage are in phase, to achieve a unity power and network elements, and the output voltage waveform distortion is low, the current waveform is close to sinusoidal.Keywords: direct drive wind power systems，agrid-con