临床药理学第章 绪论.doc

安徽医科大学药学院 临床药理学教案 李 俊 教授 2007-05-20 第 次课 授课时间 教案完成时间： 课程名称 临床药理学 年 级 专业、层次 本科 授课教师 专业技术职 务 授课方式 （大、小班） 学时 3 授课题目（章，节） 第章 基本教材或主要参考书 教学目的与要求： 大体内容与时间安排，教学方法： 教研室审阅意见： （教研室主任签名） 年 月 日  基 本 内 容 辅助手段和时间分配 以图表的方式，举例说明新药临床实验 15min 举例说明 举例 举例说明 30min 举例说明，采取提问的方式，与学生互动 详细阐述 20min 以具体的案例，分析讲解，并设计表格对比 10min 举例说明  小 结 复习思考题，作业题 实施情况及分析 Ellipticity of elbow pipes with diameters less than or equal to 150 mm must be not greater than 8% diameter of 200 mm or less shall not be greater than 6%. Wall thickness of the pipe wall thinning rate must not exceed the original 15%. Crease roughness: diameter 125 mm or less, shall not exceed 3 mm diameter less than or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2) supports and hangers of material, size and accuracy shall conform to the provisions of the design drawings, material technical requirem