皇朝娱乐会所管理大纲 定稿.doc

雅安市 皇朝娱乐会所 员 工 手 册 阅读完毕签字，即视为自愿遵守本手册的所有章程： 为了能有效提高员工工作效率，职业道德观及自身修养素质，特制定本员工手册，望各部门工作人员认真对待。本守则主要分为企业文化，管理制度两个章程。 第一章 企业文化 第一节：企业管理模式 皇朝娱乐会所内部管理模式，由董事长直接管理各部门主管，各部门主管直接管理部门员工。员工对部门主管负责，部门主管对董事长负责。 ：企业口号 以一流团队，打造企业形象 以卓越管理，树立企业品牌 以持续努力，推动企业发展 以优质服务，赢得客户满意 ：企业铁规 公司利益高于一切，公司是全体员工的生存平台，个人利益不能亦不得与之发生冲突。一旦祸起萧墙，轻则申斥处罚，重则革职走人。砸了老板或大伙儿的饭碗，谁也别想有好日子过。 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finishing. bearing surface, markup should be in accordance with the mounting support pads, and retest the thickness. Once the lifting cylinder measurement of surface