什么是phased ppap.pptVIP

7. Control Plan 控制计划 Potential Critical Characteristics and Significant Characteristics Identified DFMEA DVP R PFMEA DVPR Pre - Launch Control Plan Production Control Plan Prototype Control Plan Modification of PFMEA (as required) Standard Work Instructions/Visual Aids Process Flow Diagram Employee Customer Safety Government Regulations Design Field Actions Warranty Customer Concerns Actual Critical Characteristics and Significant Characteristics Identified 8. Measurement System Analysis 测量系统分析研究 All gauges (both general or dedicated) in Control Plan. 无论测量系统的类型是什么，用于检查福特产品的所有量具,都需进行量具再生/再现性分析。 MSA 3.0 based. 基于MSA3.0版本 Associated % tolerance and % study variation. 在总偏差中的量具误差占公差的比例和过程变差的比例。 To variable gages, the parts used for the Gauge RR study must be within Design Record specifications. 对计数型量具，用于MSA的零件必须符合设计规范。 The acceptance criteria for Gauge RR as a percent of TOLERANCE is less than 10%. If %tolerance is over 10% customer approval is needed. The Gauge is unacceptable if % tolerance is over 30%. NDC more than 5. ANOVA Method preferred with Minitab. （优先使用方差方法） 9. Dimensional Results 全尺寸报告 Dimensional Measurements to compare the actual part with the drawing (bubble prints). Default are 3 parts measured (5 pcs preferred). 比较实际零件是否符合设计记录的要求，默认三件。 If production parts will be produced from more than one cavity, mold, tool, die, pattern or production process, a dimensional evaluation on one part from each should be completed. 对于每个独立加工的过程，如：生产单元或生产线，和所有的多模腔、成型模、模型或冲模，都必须有全尺寸测量结果。 Make one of the parts measured as Master Sample“. 将其中一个零件作为标准样品 10. Material/Performance Test Results 材料/性能试验结果的记录 Where Ford specifies that materials are to be purchased from an approved supplier, the organization should contact the buyer to determine appropriate materials suppliers. 对特殊材料必须选择福特指定的供应商。 Ford PD is supposed to approve the PV test plan, and t