基坑开挖条件验收监理小结.doc.doc

上海轨道交通9号线二期3标段工程 浦明路中间风井基坑开挖条件关键工序 监　理　小　结　　　 上海浦桥工程建设监理有限公司 轨道交通9号线二期3标监理部 2007.4.10 一、 1、本工程建设监理合同及其附件； 2、本工程施工承包合同； 3、由建设单位提供认可的本工程施工设计图纸及其他设计文件； 4、经批准的施工组织设计； 5、国家和上海市关于工程建设的法律、法规、政策和有关规定； 6、《建设工程监理规范》(GB50319—2000)。 7、?工程建设标准强制性条文?和上海市?工程建设地方标准强制性条文? 《建筑工程施工质量验收统一标准》（GB50300-2001） 《混凝土结构工程施工质量及验收规范》（GB50204-2002） 《钢筋焊接及验收规程》（JGJ18-2003） 《钢筋机械连接通用技术规程》（JGJ107-2003） 《市政地下工程施工质量验收规范》（DG/TJ08-236-2006 J10819-2006） the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finishing. bearing surface, markup should be in accordance with the mounting support pads, and retes