ANSYS邓肯-张材料模型(国外英文).docVIP

ANSYS邓肯-张材料模型(国外英文资料) Landlord to ANSYS on the realization of the Duncan Zhang model is very useful, but there are several points that need to be corrected, and this is why upstairs brothers have doubts. I put the landlords code running a bit, and then made changes to the control, and now upload it, the brothers who have problems can be carefully compared, here I have some of the more obvious problems to explain: The 1.MP command does not add material directly to the unit, which is correct. Here, the landlord missed the command: MPCHG, see the revised code below. 2. questions about density. These are defined in the macro, and each modification of a material (that is, calling a Duncan subroutine) modifies the density of the material once, and other questions about the material can be modeled by analogy. 3. the question of gravity. After you call the macro, redefine the gravity in the same loop. The following is my modified landlord code, I hope to help brothers. Get initial results with APDL and paste it for interested friends. Please feel free to correct your mistakes, Welcome to perfection. Basic thinking: The key point of the Duncan Chang model is that the modulus of elasticity varies with the magnitude of the principal stress And the change of small principal stress (confining pressure), the basic idea of realizing with APDL is: Define a material number for each element, scale the load, and extract each step at the end of each load step According to the size and principal stress of the element, the elastic modulus Et of the next loading step is calculated, and the MP of each element is modified, For the next step. Well, heres a simple example of how copy goes out and runs directly. Normal three axis test simulation **********************************************************! FINISH /CLEAR /TITLE, Numerical, Simulation, of, three, axes, testing, soils, of /PREP7 *dim, SUy, array, 50, Settlement, records *dim, MaxPs, array, 120, Max, history, P1-P3 *dim, MaxDs, arr