信号类1(国外英文).docVIP

信号类1(国外英文资料) Fill in the blanks (fill the blanks with the correct answers) 1. Automatic block system, automatic block and block (semi-automatic block) are adopted in the basic block method. 2 when using the semi-automatic block method, the train will enter the interval by the signal displayed by the station signal or by the signal through the line. 3 when the station is interrupted by all telephones, the single track bus shall be written in accordance with the law of communication, and the two lane traffic shall be pressed (time interval method). 4, to block the construction of the road to open the road when the train, the train into the blockade area of driving documents for (dispatch order). 5 and four show the automatic block section, a green light and a yellow light --- allowing the train to proceed from the station, indicating the presence of (2) blocked partitions ahead of the station. 6 、 the signals of the station, the station, the route signal and the signal station are all positioned by the signal (stop signal). 7 (stop signal) when the lights of the station, the exit, the route and the signal pass out, show unknown or show incorrect. 8. The operation shall be located at both ends (500-1000) m of the construction line and its adjacent line from the construction site. 9 、 the deceleration spot is located at each (20) m of the two ends that need to be decelerated. 10, rail car even after hanging, first (test pull), to promote the speed of operation shall not exceed 20km/h, can not cross the interval operation. 11, rail car repair (divided into minor repairs, repair, overhaul and repair process) 3. 12, the signal device is generally divided into signal and (signal indicator) two categories. 13, stop, and through the shutoff signal under the condition of normal display distance not less than m (1000). 14, to accurately grasp the shunting operation speed, traction line when running in no more than (40) km/h. 15, the shunting operation to accurately grasp the s