发动机电脑针脚电压(国外英文).docVIP

发动机电脑针脚电压(国外英文资料) Section 1 the Department of public transportation First, Passat model, engine, computer, pin voltage 1.94 paragraph Component / circuit (VAG 1598/18 terminal number) test conditions and additional steps [1] test results The engine control module does not connect with the VAG 1598/18 voltage feed control components (1 and 54), the ignition switch turns off the battery voltage Voltage feed - control component relay (L and 23) ignition switch off [2] battery voltage To the fuel pump relay line (6 and 55- cross wiring), the ignition switch opens, the fuel pump should act Heating type oxygen sensor relays (1 and 28- short jumper) ignition on [2] relay should move (with sound) Failure indicator light (5 and 10- cross wiring) ignition switch on fault indicator light Ying Liang No. 7 ground wire manual transmission (7 and 23) ignition switch off battery voltage To the starter relay connection - automatic transmission (1 and 7), select P position and disconnect ignition coil about 2V The power output stage and the starter work less than the battery voltage The speed sensor (L and 65) opens the ignition switch, selects the D position, and raises and turns the left front wheel 0-4V (fluctuation) Air conditioning wiring (39 and 55) switch on ignition, switch on air conditioner to open battery voltage To the air conditioning compressor wiring (37 and 38- cross wiring), the ignition switch opens the air conditioner electromagnetic clutch action The first cylinder injectors (23 and 24) switch off the ignition 15-21.5 Second cylinder injector (3 and 23) ignition switch off 15-21.5 Third cylinder injector (23 and 26) ignition switch off 15-21.5 Fourth cylinder injector (4 and 23) ignition switch off 15-21.5 Fifth cylinder injector (23 and 25) ignition switch off 15-21.5 Sixth cylinder injector (2 and 23) ignition switch off 15-21.5 Fuel evaporative emissions system solenoid valve (23 and 31) ignition switch off 40-80 Engine coolant temperature sensor (14 and 33) ig