基于DSP直流伺服电机控制系统研究--毕业论文.docxVIP

毕业设计（论文）题目名称：基于DSP的直流伺服电机控制系统的研究（硬件）学院名称：电子信息学院班 级：学 号：学生姓名：指导教师： 论文编号：基于DSP的直流伺服电机控制系统的研究（硬件）Research on Control System of DC Servo Motor Based on DSP (Hardware)学院名称：电子信息学院班 级：学 号：姓 名：指导老师：2017年6月摘要本论文主要是对基于DSP的直流伺服电机控制系统的研究，使用的DSP是由TI公司研发的TMS320系列F28335型号的控制器，主要是研究该控制器控制直流伺服电机的整个过程。本文采用的是“整体——分开”的结构来进行论文的撰写，即先对整个控制系统进行全面的分析，再对每一个控制所需的模块进行单独的研究。本论文研究的重点是由DSP所产生的脉宽调制信号对电机的驱动模块进行脉冲输入，使电机正常运行。在整个系统中用到的模块有：电机驱动模块、光电编码器模块、光电隔离模块、霍尔电流传感器模块、电源模块、DSP芯片等等。经过仿真与调试，最后得出的结果与设计要求相符合，设计指导书上要求电机的额定电压是110V，额定功率185W，额定转速使1500转/分钟。在电机的运行参数出现偏差时，反馈调节系统经过PI调节后能迅速矫正电机的运行；在DSP产生正向脉宽调制波的占空比为0.5时电机停转、当大于0.5时电机正转、当小于0.5时电机反转。关键词：直流伺服电机，DSP，脉宽调制信号，PI调节AbstractThis is a dc servo motor contor system which is based on the DSP. What the model of DSP we chose is TMS320F28335, which is developed by the company of TI. Our main purpose is to research the whole process of how this controller can control the dc servo motor. The structure we used to write this paper is the From whole to part. It means, at first, we will analysis the whole control system comprehensively. And then, we will study each module of this controller separately.The focus of this paper is that the motors drive module be inputed by the PWM which is produced by DSP. And it makes the motor to running normally. The Modules which is used for this system, such as: Motor drive module, photoelectric encoder module, photoelectric isolation module, Holzer current sensor module, power module, the chip of DSP, and so on. After simulation and debugging, the result is meet the design standards. From the design guide, we choses the rated voltage of the motor is 110V, the rated power is 185W, and the rated speed is 1800 rpm. When the operating parameters of the motor are out of order, after PI adjustment, the feedback control systems can correct the operation of the motor rapidly; The motor is switched off when the duty cycle of the PWM wave is 0.5. When larger than 0.5, the motor is turning, and when smaller than 0.5, the