catiaV5R9零件设计教程概要1.ppt

Copyright DASSAULT SYSTEMES 2002 Part Design Advanced Course Presentation Objectives of the course In this course you will complete the knowledge acquired in the CATIA Part Design Fundamentals course Targeted audience New CATIA V5 users Prerequisites Part Design Fundamentals Table of Contents (1/2) Sketch-Based Features p.6 Holes/Pockets/Pads Not Normal to Sketch Plane p.7 Creating Grooves p.10 Creating Ribs and Slots p.17 Creating Stiffeners p.28 Creating Lofts p.34 Creating Simple Lofts p.35 Remove Lofts p.42 Coupling p.47 Creating Pads and Pockets from Surfaces p.69 3D Wireframe Elements p.73 Surface-Based Features p.79 Split p.82 Thick Surfaces p.83 Close Surfaces p.84 Sew Surfaces p.85 Advanced Drafts p.86 Thickness p.101 Table of Contents (2/2) Using Transformations p.106 Using Transformations p.107 3D Constraints p.112 3D Constraints p.113 Local Axis p.117 Customizing Local axis p.121 Analyzing Threads and Taps p.137 Draft Analysis p.141 Part Management p.146 Measure, Scan, Parent-Children p.147 Cut, Paste, Isolate, Break p.161 Inserting and Managing Bodies p.168 Multi-Model Links p.191 Sketch Selection with Multi-Document Links p.196 Scaling p.203 Sketch-Based Features You will learn to create advanced sketch-based features Holes/Pockets/Pads not Normal to Sketch Plane Creating Grooves Creating Ribs and Slots Creating Stiffeners Creating Lofts Holes/Pockets/Pads not Normal to the Sketch Plane You will learn how to create Holes, Pockets or Pads with a direction of extrusion not perpendicular to their sketch What are Holes/Pockets/Pads not Normal to the Sketch Plane ? Holes/Pockets/Pads not Normal to Sketch Plane Creating Grooves You will learn how to create grooves Creating Grooves Groove : 3D Line Axis Groove : Reverse Side Additional Information (1/3) Additional Information (2/3) Additional Information (3/3) Crea