DIY投影仪(外国英语资料).docVIP

DIY投影仪 The first part: DIY projector principle At present, DIY is mainly used to remove the projector backlight LCD to display screen, using the LCD panel, and teaching projector or homemade light source, through the LCD panel, after amplification and the formation of the projection screen and zoom. The main components and projection principle are shown in figure. Depending on the size of the LCD, the choice of fittings and the distance of the projection, the distances of the fittings will be different. The main advantages of DIY projector is a low price, the production cost is only equivalent to a fraction of the cost of commodity projectors, on the other hand, per unit time is far lower than that of commodity projectors, projector bulbs after all goods to thousands of yuan a. In addition, the fun of DIY itself is also important, and the satisfaction of being in front of a friend is something that a projector cannot buy. The main drawback is larger (my box size is about 470mm * 185mm); noise than commercial projector slightly higher (if possible I will release the Video record for reference); can not adjust the brightness, contrast and trapezoidal distortion function. The second part: the main accessories, functions and price of DIY projector Part 1 and LCD: A, removable backlit LCD display, monitor, note that not all LCD can remove the backlight and transform. B, drive board, and LCD matching, including single VGA, 3in1, 4in1 and so on. The so-called 3in1, 4in1, refers to in addition to the computer card VGA interface, but also provides S-Video, AV, TV and other interfaces of the driver board, can be directly connected to DVD, VCD or television closed-circuit and other input devices. In addition, as wiring is required, an extension line between the LCD and the drive board is usually required. C, Finel lens: including the same front and back two blocks, the main role is to parallel light, astigmatism of each other, and its size is cut into the same as the LCD pane