第五章塑料模基本结构和零部件设计(国外英文资料).docVIP

第五章塑料模基本结构和零部件设计 The fifth chapter plastic mold basic structure and parts design Fill in the blanks 1. plastic mould according to the molding method classification, can be divided into,,, According to the installation mode of the die on the forming equipment, it can be divided into, The number of cavities can be divided into two parts, . The shape of the 2. parting surface has,,,. 3., in order to facilitate the release of plastic parts, in general circumstances, so that plastic parts in the opening or stay On. The 4. parting surface selection for side parting and core pulling, if the plastic parts with side holes or concave side, side core should be set in, except for the hydraulic core pulling mechanism, the general should be a core pulling or typing on the larger Direction; for large plastic parts requiring side parting, large parting surfaces shall be located In direction. 5., in order to ensure the quality of plastic parts, when the parting surface is chosen, the plastic parts with coaxiality requirements shall be arranged in the part with coaxiality requirements. 6., in order to facilitate the exhaust, the general choice of parting surface and melt flow coincide. 7.. For the small plastic parts, the embedded multi cavity combination die is often used, and each single cavity is usually adopted, Or other methods are made and then integrated into the template. 8. factors affecting the dimensional tolerance of plastic parts are,,, ,. 9. factors affecting the shrinkage of plastic parts can be summed up as:,, ,. 10. plastic molding parts of the manufacturing tolerances about the total tolerance of plastic parts, forming parts of the maximum amount of wear, for small and medium-sized plastic parts to take; for large plastic parts are taken. 11. plastic model cavity due to the molding process by the strong pressure of the melt, may be due to lack of strength and plastic deformation, lead to reduce the plastic parts precision and influence the plastic parts. 12. the ca