Ni测温热敏电阻及电阻温度计.pdfVIP

Application Note 046 Measuring Temperature with an RTD or Thermistor What Is Temperature? Qualitatively, the temperature of an object determines the sensation of warmth or coldness felt by touching it. More specifically, temperature is a measure of the average kinetic energy of the particles in a sample of matter, expressed in units of degrees on a standard scale. RTDs and Thermistors RTDs Resistance temperature detectors (RTDs) operate on the principle of changes in electrical resistance of pure metals and are characterized by a linear positive change in resistance with temperature. Typical elements used for RTDs include nickel (Ni) and copper (Cu), but platinum (Pt) is by far the most common because of its wide temperature range, accuracy, and stability. RTDs are constructed by one of two different manufacturing configurations. Wire-wound RTDs are constructed by winding a thin wire into a coil. A more common configuration is the thin-film element, which consists of a very thin layer of metal laid out on a plastic or ceramic substrate. Thin-film elements are cheaper and more widely available because they can achieve higher nominal resistances with less platinum. To protect the RTD, a metal sheath encloses the RTD element and the lead wires connected to it. RTDs are popular because of their excellent stability, and exhibit the most linear signal with respect to temperature of any electronic temperature sensor. They are generally more expensive than alternatives, however, because of the careful construction and use of platinum. RTDs are also characterized by a slow response time and low sensitivity; and because they require current excitation, they can be prone to self-heating. RTDs are commonly categorized by their nominal resistance at 0 °C. Typical nominal resistance values for platinum thin-film R