热轧带钢层流冷却卷取温度高精度控制.pdfVIP

Advanced Materials Research Vol. 421 (2012) pp 140-146 Online available since 2011/Dec/06 at © (2012) Trans Tech Publications, Switzerland doi:10.4028//AMR.421.140 Development and Application of Advanced Coiling Temperature Control System in Hot Strip Mill Liang-gui PENG1,a, En-yang LIU1,b, Dian-hua ZHANG1,c, Xiang-hua LIU1,d, FangXu 2,e 1 The State Key Laboratory of Rolling and Automation, Northeastern University, Shenyang 110819, China 2 Hot Rolling Department, Jingtang Iron and Steel Co. Ltd , Caofeidian 063200,China a b c d penglg@, enyangliu@126.com, zdhua@, liuxh@, ex_fang@ Keywords: heat transfer; mathematic model; case-based reasoning; coiling temperature Abstract. Run out table cooling equipment and coiling temperature control (CTC) system, especially mathematic models of a hot strip mill were introduced. Heat transfer models such as air convection model, heat radiation model and laminar cooling model, process control models such as segment tracking model, feedback control model, self-learning model and case-based reasoning model were detailed described. Since online application of the new CTC system, the laminar cooling control system has been running stably and reliably with a high precision of coiling temperature. Introduction Coiling temperature is a very important factor to determine the mechanical properties of hot rolled strips such as tensile strength, yield stress and elongation of steels. Purpose of coiling temperature control (CTC) is to keep coiling temperature and/or cooling rate, cooling route as their targets which are requested to achieve material properties and microstruc