6-1第六章 管道设计（国外英文资料）.doc

6-1第六章 管道设计 This article is contributed by linnlg00 Ppt documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. Sixth chapters Piping design One Piping design 6.1, 6.2, 6.3, 6.4, 6.5, 6.6 piping design basic requirements and general procedures, piping components, piping design, piping design, piping stress analysis, piping vibration Two Introduction: Introduction: introduction of pressure pipeline Regulations special equipment supervision special equipment supervision regulations refers to the use of pressure pipeline, a certain pressure, pressure piping, refers to the use of certain pressure, tubular equipment used for transporting gas or liquid, liquid or tubular equipment, the scope of the provisions for the maximum working pressure is greater than or equal to 0.1MPa (g) gas, liquefied gas, greater than or equal to (g) gas, liquefied gas and steam medium or combustible, explosive, toxic, corrosive, flammable, explosive, or steam medium toxic, corrosive, high working temperature is higher than or equal to the standard boiling point of the liquid medium, high working temperature is higher than the or equal to the standard boiling point of the liquid medium, and the pipe nominal diameter greater than 25mm. Pipes. Pipeline and nominal diameter greater than the pressure in pipeline management equipment body belongs to a pipeline of military equipment, military equipment, vehicles and devices in home (residential buildings, indoor courtyard) (residential buildings, Garden Road) and thermal point with the gas pipe after the last valve before the life (not including heat point) life for gas pipeline and heat point (excluding heat point) after 3 Thermal Pipeline Pressure pipeline use is divided into three types of enterprises, industrial enterprises and institutions in the pipeline for conveying medium, the process pipe conveying medium of the process pipelines, utilities and other