S7-200 自由口通讯程序 方式C（国外英文资料）.docVIP

S7-200 自由口通讯程序 方式C Explains that the PLC program of this example is also borrowed from elsewhere, I just repaired it properly, and then wrote the code section of VB. One to think PLC program written well, because the program is too long, please heart looked. //^^^^^^^^^^^^^^^^^^^^^^// PLC program section TITLE= program notes //PLC performs initialization routines during the first scan and initializes the ports and the RCV instructions. When initialization is complete, the RCV command is run and the port is in the accepted state. //RCV saves the instruction at the end of the g with G to the receive buffer and generates the receive completion interrupt at the same time. //RCVcomplete interrupt service program for processing and receiving complete interrupt event, it will receive buffer of sixteen hexadecimal ASCII code reduction to save the data, and the trigger condition Verify subroutine (M0.1). The trigger condition / / Verify subroutine itself to prevent the first reset subroutine is invoked repeatedly, and then calculated BCC checksum instruction in the receive buffer and BCC check code instructions for comparison. If the flag is set equal to BCC code check the correct position (M0.0) is 1; if the instruction format is correct (instruction marks the end in a receive buffer specific location VB133) and the BCC code is not equal, is sent on behalf of the BCC checksum error feedback; if the instruction format is not correct (marked the end of VB133 not instruction), the feedback information is returned on behalf of instruction format error. / / trigger condition Read subroutine: instruction in the station address and the station address match, the type of instruction for reading instruction, BCC test code correctly. When the condition is satisfied, the Read subroutine is executed. The Read subroutine first prohibits RCV, then converts the data to be read into sixteen hexadecimal ASCII code, writes it to the transmit buffer, calculates the BCC test code, and finally