东风4D型内燃机车故障应急处理办法（国外英文资料）.docVIP

东风4D型内燃机车故障应急处理办法 Emergency treatment method of Dongfeng 4D diesel locomotive fault First, when the diesel engine does not start, how to deal with it? 1 、 confirm: the main handle is not in the 0 position, the controller No. 9 refers to the virtual connection, and the 1QA button is not good. Whether 15DZ jump. The starting contactor QC is not attracted properly. Processing: the controller touch refers to the virtual connection, 1QA is bad, can be used at the other end of the cab to start. After 45-60 seconds of skidding, press the QA button to start the machine. Note: when the diesel engine is steady and the end of the oil pressure is set up, loosen the button again. 2, confirm: stop goubei whether the sinking action, the largest oil stop is gapless. Treatment: human hard to restore the plate, goubei rises, the largest oil stop gap. 3 、 confirm whether the DLS is attracting well, whether the armature adjusting lever nut is connected or not. Handle 1: artificially top DLS or downward adjust the armature adjusting lever nut. 2: if the DLS coil burning, solid armature live, DLS coil should be removed, change a position, or with wedge and the top wire to fix the DLS pressure in the power piston stop valve on the machine. Note: the top DLS must pay close attention to checking the oil pressure of each oil pressure gauge, and the main engine oil pump fault is strictly prohibited. When the end oil pressure is lower than 100Kpa, it should be stopped immediately. It is strictly prohibited to maintain the operation blindly. 4. Confirm whether the battery is short of power and 9. The instantaneous voltage of the starting machine is less than 35 v. when it is slow to recover The treatment can open the indicator valve, reduce the load of the cylinder by throwing a few. Starting machine. Check the battery if there is reverse pole fault in the library. 5, confirm: fuel pressure without pressure, the display is normal. Processing 1: close the other end of the 4K; RBC do not smoke, a