华为钣金件设计规范（国外英文资料）.docVIP

华为钣金件设计规范 This article is contributed by Liu Zhiliang DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. DKBA HUAWEI Technology Co., Ltd. DKBA4031-2003 DKBA4031-2003.06 4031 Sheet metal structure; machinability; design specification; sheet metal structure; machinability; design specification; structural parts machinability 200306-30 release 2003-06-30 release 2003 07-XX implementation of 2003-07-XX implementation HUAWEI Technologies Ltd Classification: internal public / secret DKBAXXXX.X-2002.XX order The first 1 second Speak...... 5 scope and introduction...... 61.1, 1.2, 1.3 range...... 6 introduction...... 6 keywords...... Six 23 Normative reference file...... 6 punching...... 63.1, 3.2, 3.3, 3.4, 3.5, 6, 3.6, 3.7, 3.8, 3.8.1, 3.8.2 blanking of the shape and size as simple as possible symmetry, so that the layout of the waste at least...... 6 punching parts should avoid cantilever and narrow long slot...... 7 punching holes are preferred, and the punching holes have minimum size requirements...... 7 cutting hole spacing and hole margin...... 8 when the punching and drawing parts are punched, the hole wall and the straight wall should be kept a certain distance between the 8 screws, the bolt through hole and the countersunk head seat...... Limit value and design mark of burr of 8 blanking parts...... Limit value of burrs for 9 blanking parts...... 9 marking requirements for burrs in design drawings...... Nine Four Bend...... Minimum bending radius of 104.1, 4.2, 4.2.1 bending parts...... 10 straight edge height of bending parts...... 10 minimum vertical height requirements in general conditions...... Ten 2010-04-10,01:42:36 Two Classification: internal public / secret DKBAXXXX.X-2002.XX 4.2.2, 4.2.3, 4.3, 4.4, 4.4.1, 4.4.2, 4.5, 4.6, 4.7, 4.8, 4.9, 4.9.1, 4.9.2, Straight edge height for special requirements...... The straight edge height of 11 curved sides with bev