13春学期《液压气动技术》在线作业1(外国英文资料).docVIP

13春学期《液压气动技术》在线作业1 Northeastern University 14 spring 13 autumn East 13 spring semester hydraulic pneumatic technology online homework 1 Total score: 100 test time: - Radio examination A multiple-choice question Judgment question Radio examination questions (10 questions, 50 points) 1. when the inlet pressure of the pressure reducing valve is basically constant, if the flow rate increases, then the oil pressure is applied. A. increase B. decrease C. invariant D. is uncertain Full marks: 5 2. the principle of hydraulic transmission is based on () A. law of conservation of energy B. momentum theorem C. law of conservation of mass D. Pascal principle Full marks: 5 3. large flow of hydraulic system, the main valve should be used () reversing valve. A. electromagnetic B. Electric liquid C. manual D. maneuver Full marks: 5 4. speed control valve is made of (). A. throttle valve and sequence valve in series B. throttling valve and differential pressure reducing valve are connected in series C. throttle valve and sequence valve in parallel D. throttling valve and constant pressure reducing valve are connected in parallel Full marks: 5 5., there are two adjustment pressures are 5MPa and 10MPa, internal control leakage sequence valve series in the oil pump outlet, the pump outlet pressure is (). A. 5MPa B. 10MPa C. 15MPa D. 30MPa Full marks: 5 6., when there is negative (dynamic) load, it is better to adopt () the speed regulating loop. A. inlet throttle speed regulation (no back pressure valve) B. return circuit throttling speed regulation C. bypass throttling control D. intake line throttle speed regulation (plus back pressure valve) Full marks: 5 7. return oil throttling speed regulating circuit () The speed regulating characteristic of A. is different from that of oil inlet throttling speed regulation circuit B. the oil heated by the throttling valve is not easy to heat C. It is widely used in hydraulic systems with little power, large load variation or high stability of