碳纳米管场发射荧光管的制备及性能研究_完整版概要1.docVIP

XX大学 学 士 学 位 论 文 题 目 碳纳米管场发射荧光管的制备方法及性能研究 学 院： 系 专业班级： 学生姓名： 学号： 指导教师： 职称： 起讫日期： 碳纳米管场发射荧光管的制备方法及性能研究 专 业： 学 号： 学生姓名： 指导教师： 摘要 场发射光源具有高亮度、低功耗、无污染、长寿命等,因此近年来越来越受人们的欢迎。本围绕碳纳米管场发射荧光管研究,阳极荧光屏的制作,展了阳极ITO透明导电层的研制、荧光粉层的涂敷工艺研究及荧光管的组装与测试三部分工作。首先研究了ITO薄膜的溶胶凝胶。乙酰丙酮硝酸铟、氯化锡配制溶胶,在普通玻璃基底与玻璃管内壁上拉制湿膜,烧结热处理制备ITO薄膜。,采用电泳法涂覆荧光粉层,组装碳纳米管场发射荧光管,在真空环境下进行动态点亮测试。 关键词 碳纳米管； 场发射荧光管； Study on the preparation and properties of carbon nanotube field emission fluorescent tube ABSTRACT Field emission light source has the advantages of high brightness, low power consumption, no pollution, long life and so on. Therefore, it has become a hot research topic in recent years. This paper focuses on the carbon nanotube field emission fluorescent tube of practical research, aiming at the anode screen making, ITO transparent conductive layer of the fluorescent powder layer and in the development of coating technology research and a fluorescent tube assembly and test three parts work. Firstly, the preparation process of ITO thin film by sol gel method was studied. To, acetyl acetone, indium nitrate, stannic chloride as raw materials preparation of sol, by using the Czochralski method in ordinary glass substrate and the glass tube on the inner wall of the drawing of wet film. Finally, thermal sintering processing of preparation of ITO thin films. The effects of indium ion concentration, Sn molar ratio and heat treatment temperature on the structure, morphology and photoelectric properties of ITO thin films were investigated. Secondly, the influence of preparation parameters on the thickness and surface morphology of the phosphor layer was studied by electrophoretic coating, and the optimum technological parameters were determined. Finally, the carbon nanotube field emi