地暖设计规范(国外英文资料).docVIP

地暖设计规范 This article is contributed by lzn0125210 DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. The temperature of supply and return water of 3.1.1 low temperature hot water ground heating system shall be determined by calculation, and the water supply temperature shall not be greater than 60 degrees centigrade. The temperature of water supply in civil buildings should be 35~50 degrees centigrade, and the temperature difference between supply and return should not be greater than 10 degrees centigrade. The average surface temperature of 3.1.2 shall be calculated in accordance with the provisions of table 3.1.2. Table 3.1.2 surface area average temperature (temperature) regional characteristics, personnel stay area, short stay area, no human residence area, 35~404228 to 3032, suitable range 24~26, maximum limit 28 The working pressure of 3.1.3 low temperature hot water ground heating system should not be greater than 0.8MPa. When the building height exceeds 50m, it should be set vertically. 3.1.4 no matter what heat source is adopted, the parameters such as temperature, flow rate and pressure difference of the heat medium in the low temperature hot water ground heating system should be matched with the heat source system. The heat source system shall be provided with corresponding control devices. The content and depth of 3.1.5 ground radiation heating engineering construction drawings and design documents, shall meet the following requirements: 1 construction drawings and design documents should be based on the construction drawings, including drawings, catalog design specifications, heating pipes or heating cable layout, temperature control device layout and water separator, a water collector, ground structure diagram etc.. Two Design specification shall describe the calculation of temperature, indoor and outdoor heating heat source and heat medium parameters, d