Reliability analysis of structural stainless steel design provisions（可以看一下4.2前的内容）.pdfVIP

Journal of Constructional Steel Research 114 (2015) 293 –304 Contents lists available at ScienceDirect Journal of Constructional Steel Research Reliability analysis of structural stainless steel design provisions S. Afshan a,⁎, P. Francis b, N.R. Baddoo b, L. Gardner a a Imperial College London, London, UK b The Steel Construction Institute, Ascot, UK a r t i c l e i n f o a b s t r a c t Article history: Since the establishment of the Eurocode design provisions for structural stainless steel, a considerable amount of Received 17 December 2014 both statistical material data and experimental results on structural elements has been generated. In light of this, Received in revised form 28 July 2015 the current partial resistance factors recommended in EN 1993-1-4 for the design of stainless steel elements are Accepted 3 August 2015 re-evaluated. First, following an analysis of material data from key stainless steel producers, representative values Available online 15 August 2015 of the over-strength and the coefficient of variation (COV) of the material yield strength and ultimate tensile Keywords: strength were established. For yield strength, over-strength values and COVs of 1.3 and 0.060 for austenitic, 1.1 Material over-strength and 0.030 for duplex and 1.2 and 0.045 for ferritic stainless steels were determined. For the ultimate tensile Partial factors strength, an over-strength value of 1.1 was found t